Safety Instructions

4. Cannot connect to Wi-Fi.
Do not skip the Wi-Fi connecting steps in the app.
5. Cannot connect to Alexa.
Pull out every connective pa of the Strip Light and rmly re-connect them.
Re-connect your phone to Wi-Fi.
Plug out the adapter po and re-plug it in.
5GHz network is not suppoed. Please set the router to 2.4GHz and then reset it.
Connect your phone to Wi-Fi and check whether the network works well.
Make sure you have entered the correct Wi-Fi name and password.
Change your Wi-Fi password to a brief one. 8 numbers and leers are suggested.
Connect hotspot in your phone to the Strip Light and check whether the router works with
the Strip Light.
FCC Radiation Exposure Statement
Manufacturer: Shenzhen Linklite Sma Lighting Co., Ltd.
Address: 4th oor, 3 building ,Yangbei industrial park 1st phase, Huangtian,
Hangcheng street, Bao'an distr, Shenzhen, Guangdong Province, China
Made in China
This device complies with Pa 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this devicc may not causc harmful inteerence, and (2) this device must accept
any inteerence received, including inteerence that may cause undesired operation.
changes or modications not expressly approved by the pay responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Pa 15 of the FCC Rulcs. These limits are
designed to provide reasonable protection against harmful inteerence in a
residential installation. This quipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful inteerence to radio communications. However,
there is no guarante that inteerence will not occur in a paicular installation.
If this equipment does cause harmful inteerence to radio or television reception,
which can be determined by turning the cquipment o and on, the user is
encouraged to try to correct the inteerence by one or more of the following
mcasures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the cquipment and receiver,
- Connect the quipment into an outlet on a circuit different
from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with any other
antenna or transmitter
- FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment . This equipment should be installed and operated with a minumum
distance of 20 cm between the radiator and your body.