User's Manual

10 11 12 13 14 15 16 17
Customer Service
FCC WARNING
Step 4: You can adjust the ball-joint rotation of the vent
mount, so your device is in either portrait or landscape
orientation. And then tighten the rotation to fix the position
until it rests firmly.
Step 3: Attach your compatible phone on the vent mount. The
vent mount starts charging your phone immediately and
holds securely.
Note: Fast charging will only be supported when using a
QC 3.0 adapter with an output over 18W and a USB cable
supporting 3A power output.
Items specification
Input Voltage 5V ~9V
Input Current ≤2A
Max Output Power 10W
Transmission Distance ≤5mm
Transfer Efficiency 75% Max
Operating Temperature -10℃~30℃
Storage Temperature -20℃~60℃
Working Frequency 110KHz-205KHz
The PITAKA MagMount Qi is warranted for 12 months
from the date of purchase. The MagMount Qi is
warranted to be free defects in materials and function
under normal use for the lifetime of the product. A
defect is defined as an imperfection or flaw that is
produced by a manufacturing error, including
malfunction of wireless charging or surface defect, etc.
This warranty is non-transferable and covers only the
original end-user purchaser. PITAKA will only authorize
the warranty claim if the product was purchased from
the official store or authorized dealer.
Damages don’t cover those resulting from abuse, not
correctly maintained, alteration or misuse (including
disassemble, drops), abnormal wear and tear, cosmetic
damages that do not affect the functionality.
Read all instructions and warnings before using this
product. Improper use may result in product damage,
excess heat, toxic fumes, fire or explosion, for which
damages PITAKA is not responsible.
1) DO NOT DIRECT HEATED AIR FROM THE VENT ONTO
THE MOUNT WHILE IT IS ATTACHED TO THE VENT. When
running the car’s heater, make sure you close the vent
that the mount is attached to or take the mount from the
car vent directly, or direct the heated air out of the car’s
lower vents and away from the upper vents.
2) Do not keep the MagMount Qi in a high-temperature
environment, including heat caused by intense sunlight
or other forms of heat. Do not place it in the fire or other
excessively hot environments.
3) Do not disassemble the New MagMount Qi or attempt
to modify it in any way.
4) Do not attempt to power the New MagMount Qi with
any connection other than the Type-C connector.
5) Do not attempt to replace any part of the New MagMount
Qi.
6) All products have gone through a thorough quality
assurance inspection. If you find that your New MagMount
Qi is excessively hot, is emitting odor, is deformed, abraded,
cut or is experiencing or demonstrating an abnormal
phenomenon, immediately stop all product use and contact
Manufacturer.
7) If this New MagMount Qi is intended by the purchaser to
be used by a minor, purchasing adult agrees to provide
detailed instructions and warnings to any minor before use.
Failure to do so is the sole responsibility of the purchaser,
who agrees to indemnify Manufacturer for any unintended
use/misuse by a minor.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation. Any
changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician
for help.
The device has been evaluated to meet the general RF
exposure requirement.
FCC ID: 2ARI5-CM3001Q
Phone：[phone]
E-mail: [e-mail]
Website: www.ipitaka.com
MODIFICATION：Any change or modification of
this device will void the warranty.
Exclusion
ROTATE 360
2.3072
3.0768
DC 9V/1.1A
DC 5V/1A
Rated output voltage/ current
(Fast charging)
Rated Output Voltage/ Current
(Normal charging)
2.8154
Warranty
Spec
Important
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.