User's Manual

power adapter plug to the camera to have it power on;
3.Keep the distance of each camera beyond 2 meters if more than 2pcs of cameras are
mounted; keep the distance between the camera and the receiver beyond 2 meters, otherwise
they will interfere each other and cause a poor picture.
4.Mount the 2.4G antenna to the receiver;
5.Connect the video/audio interface of the receiver to the TV or monitor with AV cord;
6.Insert the DC+12V/500mA power adapter to the alternating current socket, conect the DC
power adapter to the receiver to have it power on;
7.Select the frequency channel switch to keep the receiver and the camera with the same
frequencies;
8.You can see the pictures and hear the voice through TV, adjust the location of the camera to
have a efficacious surveillance.
9.If you don’t want to use the receiver, you can connect the AV cord of the camera directly to
the video/audio interface of TV or monitor to display the picture.
Trouble shooting guide
1.No signals on TV or monitor
Please check if the power adapter of the camera is well connected with the alternating
current socket, if the alternating current is power on, or if power adapter of the camera is well
inserted into the power input jack of the receiver;
2.Can’t pick up the picture or the picture is not clear:
Please check if the camera is power on; or if the camera is too far away from the
receiver(open distance is 500800m); or if there are some electromagnetism barrier between
the camera and the receiver(for example the steel building); or if the camera and the receiver
are on the same channel( be attention that two cameras with the same transmitting frequency
can not work synchronously in valid distance, otherwise they will interfere each other); make
sure that the antenna is well mounted on the receiver.
Keep the antenna of the receiver far away from copper&iron electromagnetism barriers,
Powerful same frequency transmitter or or radio station will cause interfere to the receiver.
Accessories:
Antenna 1piece
AV cord 1piece
DC12V/500mA power adapter 1piece
Manual 1piece
Warranty card 1piece
Receiver 1pieceoptional
Caution:
Changes or modifications to this unit not expressly approved by the party responsible for compliance will void
the user’s authority to operate the equipment. Any change to the equipment will void FCC grant.
NOTE:
This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.