User's Manual

3. Operation Instruction:
1) Put the camera in the direction you want to monitor.
2) Insert DC8V/200mA power adapter into the interflow power plug, and insert its DC output
plug into the DC input plug of the camera and turn power on.
3) Please put cameras 2 meters away from each other when two or more cameras used
simultaneously. The distance between receiver and cameras should be more than 2 Meters
too, otherwise signal interference would influence receiving result.
4) Fix 2.4G antenna to the camera ANT jack and screw down.
5)
Connect receiver and TV or monitor with AV cable;
6) Insert DC12V/500mA power adapter into the interflow power plug, and insert its DC
output plug into receiver’s input plug, then turn power on.
7) Choose proper receiving channel to make the frequency be the same with frequency of
transmitter.
8)
Connect camera and TV or monitor with AV cable, you may get audio and video signals.
4. Problems and solving：
1)
There is no image on TV or monitor screen
▲Please check whether the TV or monitor’s power adapter has been installed well or not.
▲Please Check whether the key of the power adapter has been turn on or not
▲Please check whether power adapter has been insert to receiver’s input power jack.
2) There is no image or the image is not clear
▲ Please check camera power adapter has been switched.
▲ Please check if the distance is too long between the camera and receiver (The direct
distance should be within 500-800m), or if there are any electromagnetism obstruction
around (e.g. steel construction will counteract transmitting signals.)
▲ Please make sure the frequency of the wireless camera is the same as that of receiver.
(Two cameras with the same frequency can not work properly within effective distance,
thus interference will be caused)
▲ Please confirm the receiver antenna has been fixed.
▲ Please keep far away from big copper or iron electromagnetism obstruction. High-power
transmitter in the same frequency and car broadcasting station may also cause interference.
5.Accessories:
Antenna one piece
AV cable one piece
DC8V/200mA power adapter one piece
Manual one piece
Receiver one set (optional)
Guarantee Card one piece
Caution:
Changes or modifications to this unit not expressly approved by the party responsible for compliance will void
the user’s authority to operate the equipment. Any change to the equipment will void FCC grant.