User Manual

Shenzhen Lean Kiosk Systems Co., Ltd
5 Add: Fu'an Industrial Area, Dayang Road, Fuyong Town, Baoan District, Shenzhen, Guangdong Province, China.
Stock Code
:
870885
Installation Guide
Introduction
This Post Kiosk is a type of intelligent terminal which is used in the intelligent identification management
system of the parking lot. The purpose is to realize 24 hours unattended management payment of the parking
lot for the property management company, and to provide the owners with a more convenient and efficient
way of self-service inquiry and payment. Shenzhen Lean Kiosk Systems CO., LTD is major in developing and
researching the self-service payment system in intelligent parking lot actively for many years and has
obtained very good practical effect to solve many payment problems existed in traditional parking lot. This
article elaborated the specifications and installation instructions of the kiosks, which are helpful for customer
to operate the kiosks properly.
Revision of Installation Guide
Serial No. Date Revision Description
REEF-US-LKS8345A March,2020 Post Kiosk Installation Document Version No. 20.0.1
This installation guide describes the ground installation method of the kiosk cabinet, the access method
of the power supply cable and network cable, the installation method of the internal dehumidifier drainage
pipe.
Attention: This installation guide is for the standard installation order and method. If you have any
questions during the installation, please contact LKS technician.
Installation Procedure
Please evaluate and check the following environmental factors before installing the Post Kiosk:
Attention
▶Security : As the overall structure material of the Post Kiosk cabinet is cold-roll steel sheet and it is quite
heavy, for safety purpose, the kiosks must be installed on the ground with firm concrete horizontal floor as
the installation platform.
▶Reasonable Location:The installation location should be chosen in a reasonable area, where is easy for
customer to see and operate the kiosks without causing interference to other pedestrians.
▶Power Supply Description： The input voltage of the kiosk in normal operation is "single-phase 110V AC
voltage"; The power cord and network cable will go through from the bottom /base of the kiosk then enter
into the kiosk cabinet, and the ground installation platform should be pre-set the entrance hole for the
cables in advance.