User Manual

Shenzhen Lean Kiosk Systems Co., Ltd
Contact: Jesmine Zhu;Tel: [phone] ; E-mail: [e-mail] ; Website: www.lkskiosk.com / www.lien.cn;
22 Add: Fu'an Industrial Area, Dayang Road, Fuyong Town, Baoan District, Shenzhen, Guangdong Province, China.
Stock Code
:
870885
Attention：When install the keypad, the sealing tape on the edge of the keypad should be evenly
coated with a layer of organic flame retardant silicone, to ensure that the edge of keypad and cabinet
installation hole edge sealed tight enough.
■ Replace Ingenico IUC-285 Credit Card Reader
1. Unplug the USB port of the card reader before disassembling, untie the ribbon and tie up the serial
port cable.
2. Use a cross screwdriver to loosen and remove the 4 M3 assembly screws that hold the credit card
reader. The card reader can be removed from the front of the cabinet. (as shown picture below :)
Attention：When the credit card reader is installed, the edge sealing tape of the card reader shall be
coated with a layer of flame retardant silicone evenly to ensure that the edge of the card reader and the edge
of the cabinet installation hole are sealed tightly to prevent water from entering the cabinet.
■ Replace the Help Button
1. Use a flat screwdriver to remove the connection between the button and the call controller.
2. Loosen and remove the fixing nut of the metal help button with an open spanner 14-17, then the
button body can be removed from the front of the cabinet.
3. When installing the metal help button, it needs to smear a layer of flame-retardant silicone on the edge
of the waterproof ring evenly to prevent water seepage at the edge of the button into the kiosk cabinet.