User Manual

Shenzhen Lean Kiosk Systems Co., Ltd
Contact: Jesmine Zhu;Tel: [phone] ; E-mail: [e-mail] ; Website: www.lkskiosk.com / www.lien.cn;
8 Add: Fu'an Industrial Area, Dayang Road, Fuyong Town, Baoan District, Shenzhen, Guangdong Province, China.
Stock Code
:
870885
■ Construction of In-lane Kiosk Base
The surface of the poured concrete base used to install the kiosk must be a standard horizontal plane.
If install the kiosk in a slant base, it may cause the kiosk fall down or malfunction.
The poured concrete base shall not be too high from the horizontal ground, so that users with disabilities
can operate the kiosk normally while sitting in a wheelchair.
Attention：The operating position of the customer in front of the kiosk, the operating distance and
width on both sides of the customer must meet the requirements of the normal parking space of the
wheelchair, so that the disabled can operate the kiosk more conveniently.
■ Application Details
1. Confirm whether the construction site meets the horizontal positioning and installation dimensions of
the standard base..
2. The power cord and network cable will go through from the bottom /base of the kiosk then enter into the kiosk cabinet, and
the ground installation platform should pre-set the entrance hole for the cables in advance.
3. Since there are drain-pipes from air conditioner and dehumidifier inside the kiosk bottom, the ground installation platform
for the kiosk must be designed and reserved smooth drainage holes in advance.
4. Corrosion resistant and flame-retardant PVC pipes shall be used for the wire and drain holes inside the base.
5. Since the weight of the kiosk is measured by is pound, it should ensure that the kiosk is firmly installed on the street and will
not tilt or shift under the thrust of 1,200 pounds.
6. The dimension of kiosk base is measured by feet, it should ensure that the installation platform must be poured with
cement in enough depth.
7. Since 4 pieces mounting holes with φ0.6inch diameter are reserved at the bottom of kiosk, the construction personnel
just need to use 4 pieces φ0.47inch*4inch stainless steel expansion anchor bolt to fix the kiosk into the installation
platform.