User Manual

Shenzhen Lean Kiosk Systems Co., Ltd
Contact: Jesmine Zhu;Tel: [phone] ; E-mail: [e-mail] ; Website: www.lkskiosk.com / www.lien.cn;
23 Add: Fu'an Industrial Area, Dayang Road, Fuyong Town, Baoan District, Shenzhen, Guangdong Province, China.
Stock Code
:
870885
■ Replace Ingenico IUC-285 Credit Card Reader
1. Unplug the USB port of the card reader before disassembling, untie the ribbon and tie up the serial port cable.
2. Use a cross screwdriver to loosen and remove the 4 M3 assembly screws that hold the credit card reader. The card reader
can be removed from the front of the cabinet. (as shown picture below :)
Attention：When the credit card reader is installed, the edge sealing tape of the card reader shall be
coated with a layer of flame retardant silicone evenly to ensure that the edge of the card reader
and the edge of the cabinet installation hole are sealed tightly to prevent water from entering the
cabinet.
■Replace the Help Button
1. Use a flat screwdriver to remove the connection between the button and the call controller.
2. Loosen and remove the fixing nut of the metal help button with an open spanner 14-17, then the button
body can be removed from the front of the cabinet.
3. When installing the metal help button, it needs to smear a layer of flame-retardant silicone on the edge of
the waterproof ring evenly to prevent water seepage at the edge of the button into the kiosk cabinet.