User Manual

Shenzhen Lean Kiosk Systems Co., Ltd
Contact: Jesmine Zhu;Tel: [phone] ; E-mail: [e-mail] ; Website: www.lkskiosk.com / www.lien.cn;
22 Add: Fu'an Industrial Area, Dayang Road, Fuyong Town, Baoan District, Shenzhen, Guangdong Province, China.
Stock Code
:
870885
■ Replace the Keypad
1. Unplug the USB connector of the keypad before disassembling.
2. Remove the 4 pieces M3 stainless steel flange nuts that hold the keypad with the hexagon socket (0.22inch) and then take
out the keypad.
3. To replace the new keypad, organic flame-retardant silicone shall be daub on the edge of the keypad to ensure that the
edge of the keypad sealed well enough and no water sink into the kiosk cabinet (as shown in picture below)
Attention：When install the keypad, the sealing tape on the edge of the keypad should be evenly
coated with a layer of organic flame retardant silicone, to ensure that the edge of keypad and cabinet
installation hole edge sealed tight enough.
■ Replace RFID Card Reader
1. Unplug the USB port from the card reader before removing it.
2.Loosen and remove the M4 stainless steel flange nuts with the hexagon socket (0.28inch), and remove the transparent acrylic
mounting plate and card reader together (as shown in picture below)