User Manual

Shenzhen Lean Kiosk Systems Co., Ltd
Contact: Jesmine Zhu;Tel: [phone] ; E-mail: [e-mail] ; Website: www.lkskiosk.com / www.lien.cn;
20 Add: Fu'an Industrial Area, Dayang Road, Fuyong Town, Baoan District, Shenzhen, Guangdong Province, China.
Stock Code
:
870885
■ Replace the 15inch LCD Display
1. Open the kiosk back door and turn off the main power switch.
2. Unplug the display power cord, DP signal cable and ground line on the drive board in the back side of display screen and
remove the wiring and ground cable on the touch screen drive board.
4. Loosen and remove the stainless-steel flange nut of M4 with the soft hexagon socket (0.28inch specification) and remove
the whole display module from the device.
5. Place the removed LCD display flat on the operating platform, remove the screen cable and backlit
power cord on the back of display, and remove the M3 combination screw on both sides of the display with a cross
screwdriver to remove the LCD display (as shown in the picture below)
Attention：When removing the LCD display from the device, pay attention to the thin copper wire of the touch screen.
The copper wire is very thin, and the internal wire is very fine, which are easy to break and damage.
■ Replace the Side 29inch LCD Advertising Screen
1. Open the kiosk back door and turn off the main power switch.
2. Unplug the display power cord, DP signal line and ground line on the drive board
In the back side of LCD display.
3. Loosen and remove the stainless-steel combination screw of M4 with a cross screwdriver to remove the entire LCD display
from the kiosk cabinet.