Instruction Manual

Note 1: According to different simulation-needed bodies, users can choose the type of electrode pad

based on their own situation. S3 Electronic Pulse Stimulator is suitable for the

simulation-needed bodies including hips, arms and legs, abdomen, and feet. Each package is

only equipped with one electrode pad by default, and the users can select and purchase the

type of electrode pad according to their needs.

Note 2: Remote control is an optional component, and users can choose to purchase according to

their needs.

3.2 Product Structure

Electronic Pulse Stimulator is mainly composed of controller, remote control (optional) and USB

charging cable and electrode pad, and it powered by the built-in rechargeable battery.

3.3 Functions of the Electronic Pulse Stimulator

■ Controller (Main unit)

Power ON/OFF button

ON/OFF button is a toggle button and used to turn on/off the device.

With device off, short press the button to start up and the LED light turns to be blue entering Mode 1.

With device on, short press the button again to shutdown and LED light turns off.

(M) Mode Selection button

"M" button is a mode selection button to select 2 modes.

Short press the (M) button to select the mode between Mode 1 and Mode 2, the default mode is

Mode 1 and LED light to be blue. When switch to Mode 2, the LED light turns to green from blue.

Treatment program of the S3 Series

Program Name

Treatment Time (min.) Frequency (Hz) Pulse Width (μs)

Mode 1

25 minutes 4-35

200μs

Mode 2

25 minutes

4-41

200μs

Intensity Adjustment button

Intensity Adjustment button is composed of intensity (+)/increase and (-)/decrease two buttons.

"+" button is an intensity level plus button. Short press the (+) button, the intensity level will be higher

by one count, up to a maximum of 15, corresponding with a ﬂashing.

"-" is an intensity level minus button. Press the (-) button, the intensity level will be lower by one count,

down to the minimum of 1, corresponding with a ﬂashing