Instruction Manual
Other Functions
1) Low Voltage Indication
When the device is in low power, its LED light will flash to remind you.
2) No-load Indication
If there is no load, its LED light will flash and then to be turned off.
Battery charged
1) Plug in the controller through micro USB charging cable (included);
2) Connect the USB charging cable with AC/DC adapter (not included);
3) The LED light on the main unit will turn white while it's being charged.
4) LED light becomes solid blue when the controller is charged fully
5. Cleaning and Maintenance
Cleaning
1) When the controller is dirty, use dry soft cloth to wipe it.
2) Keep the surface of electrode pads clean, avoid dust, oily matter, viscous matter, or else the
viscidity of electrode pads will lower. When the surface of the pads is dirty, use water to clean it
and dry it before using again.
Storage
Keep the whole set of the product clean and store in a dust free and dry location under the condition:
Storage temperature and humidity: -25~+70℃, 0~90%RH
Maintenance
In case of any problems or malfunction, please follow the "Section 7.Trouble Shooting" in this article.
If your device does not still perform, please contact the authorized after-sales service.
DO NOT disassemble the device by yourself.
6. Disposal
DO NOT throw away the device with normal household waste at the end of its life,
but hand it in to an official collection point for recycling (Contact your local town or
city officials for recycling information). By doing this, you help to preserve the
environment.
7. Trouble Shooting
If your device is not operating properly, please check below for common problems and suggested
solutions. If the recommended action does not solve the problem, please contact our after-sales
service
15