Instruction Manual

How to operate the remote control?
1) Open the battery cover behind the remote control.
2) Put the one Button Cell Battery (not included) into the battery cassette in correct polarities.
3) Close the battery cover.
4) The functions of buttons on the remote control are the same as those on the main unit (See
for 3.3 details)
Pad aftercare
Please refer to the following use instruction for the electrode pads. Each pad is recommended about
30 (applicable for hips pad, abdomen pad, arm and leg pad) or 180 times (applicable for feet pad).
When the service life of the pad is exhausted, please replace a new and purchase it from the
manufacturer or the appointed supplier.
- Use Direction
1) Clean skin thoroughly prior to each application of electrode pads, which will not stick well if any
lotion, make-up, or dirt is left on the body skin.
2) Ensure the device is off before applying the pad to it.
3) Apply the electrode pad-installed device firmly to the body skin.
- Removal and Storage
1) Turn the device off before removing the electrode pad from the body skin.
2) Grab the edge of the pad and remove from the body area.
3) When the surface of the pads is dirty, use water to clean it and dry it before using again.
4) When not in use, store the electrode pad in the re-sealable bag, out of direct sunlight.
Auto Functions
1) Automatic Shutdown
For your safety, the automatic stimulation period is 25 minutes. After 25 minutes of stimulation,
the controller will automatically switch itself off regardless of the level or mode selected.
If you want to stop your stimulation before the end of the programmed time, press the ON/OFF
on the controller or remote control, the controller to be turned off.
2) Automatic Setting
For your convenience, the controller will enter the mode to be Mode 1 and the intensity level to
be 1 when power-on.
For your convenience, the controller will automatically turn the intensity level to be 1 if you change
the mode.
14