Instruction Manual

4th Step- Press the Power "ON/OFF" to turn on the power
Press the "ON/OFF" button once to turn on the controller/
(remote control) and the controller automatically starts at level
1 intensity. LED light turns to be blue showing Mode 1.
ON/OFF
5th Step- Select the treatment intensity
Press the (+) button to increase the stimulation intensity and press
the (-) button to decrease the intensity. Intensity levels range from1
to 15
Intensity change
6th Step- Mode switch
Press (M) button to switch Mode 1 to Mode 2. LED light turns to be
green from blue.
Mode change
7th Step- Stay with the treatment
Enjoy the treatment provided by the Electronic Pulse Stimulator,
after the above mode and intensity were set up
Note: With the increase of intensity, you may experience sensations
like tingling, vibration, etc. Therefore, gradually increase the intensity,
and stop increasing when a comfortable level is reached.
8th Step- End the treatment
Press the ON/OFF to turn off the power after done.
Or Electronic Pulse Stimulator will automatically shut off up to 25
minutes when LED light continuously flashes 3 times.
Note: When not in use, store the device and its accessories in a cool
place, out of direct sunlight.
ON/OFF
/
13