Instruction Manual
4 How the Device Uses
The following steps are used to guide the device operation, and the details about each step are listed
in the following table
1st Step- Check the battery power for the Electronic Pulse Stimulator.
Electronic Pulse Stimulator comes with a built-in rechargeable
battery and could be used as received. If the battery icon is flashing
when turned on, it means the battery is running out of power. Turn
off and charge the controller with the enclosed USB charging cable.
The LED light white during charging, and becomes solid blue when
the controller is charged fully.
2nd Step- Select and install the electrode pad onto the Electronic Pulse Stimulator
Battery charging
Follow the schematic to install the pad included onto the back side of the Electronic Pulse Stimulator.
This should be done prior to applying the device onto the skin of treatment areas.
Electrode pad installation
11
Abdomen pad-installed
Arms and legspad-installed
Feet pad-installed
HIPspad-installed