User's Manual

2) Wireless projection

Step 1: First use type-C cable to connect the computer and helmet for

wired screen projection;

Step 2: Click the small arrow in the red box on the main screen to

enter the next interface, and select “setting” (See Figure 32)

Step 3: Connect the helmet and computer to the same WiFi;

Step 4: Return to the operation interface of QtScrcpy after the

connection is completed, and click [Get Device IP] ;

Step 5: Click [Start adbd];

Step 6: Click [Wireless Connection];

Step 7: Unplug the type-C cable, plug in the infrared module, and

then click [Refresh Device List] to select the IP corresponding to the

device;

Step 8: Click [Start Service] to complete the wireless projection.