Product Specs

Shenzhen KTC Commercial Display Technology CO.,LTD.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. And the
module should be installed at a minimum distance of 20 cm away from person nearby. The host product manufacturer should state this
information to the host instruction manual.
- Trace antenna designs
Not applicable.
- RF exposure considerations
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter. This modular must be installed and operated with a
minimum distance of 20 cm between the radiator and user body.
- Antennas
Antenna Type: External Antenna
Antenna Gain:
2.4G WIFI：2.06 dBi
5.2G WIFI：1.67 dBi
5.3G WIFI：1.75 dBi
5.6G WIFI：2.8 dBi
5.8G WIFI：1.12 dBi
B T: ：2.06 dBi
- Label and compliance information
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
If the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: 2AQ5RWRTL8822BU Or Contains FCC ID: 2AQ5RWRTL8822BU”.