Product Specs

Shenzhen KTC Commercial Display Technology CO.,LTD.
the module is installed must also display a label referring to the enclosed
module. This exterior label can use wording such as the following:
“Contains Transmitter Module FCC ID: 2AQ5RWF-M68B-UWK1 Or Contains
FCC ID: 2AQ5RWF-M68B-UWK1 ”.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
- Information on test modes and additional testing requirements
Any final host product with the modular transmitter installed should be
under test according to guidance given in KDB 996369 D04. To enter test
mode for module, WCN_Combo_Tool_Setup_customer and QATool_Dbg software
and command is necessary. When something wrong happens in configuring test
modes for host product with module, host product manufacturer should
coordinate with module manufacturer for technical support. It is
recommended that some investigative measurements should be taken to
confirm that host product with module installed does not exceed the
spurious emissions limits or band edge limits.
- Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts
(FCC Part 15.247&15.407) list on the grant, and that the host product
manufacturer is responsible for compliance to any other FCC rules that
apply to the host not covered by the modular transmitter grant of
certification. The final host product still requires Part 15 Subpart B
compliance testing with the modular transmitter installed when contains
digital circuity.