User's Manual

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditio

ns:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital devi

ce, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can rad

iate radio frequency energy and, if not installed and used in accordance with the instructions, may ca

use harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is enco

uraged to try to correct the interference by one or more of the following measures:

‐ Reorient or relocate the receiving antenna.

‐Consult the dealer or an experienced radio/TV technician for help important announcement

Important Note:

In the event that these conditions cannot be met (for example certain laptop configurations or co-

location with another transmitter), then the FCC authorization is no longer considered valid and the

FCC ID cannot be used on the final product. In these circumstances, the OEM integrator will be

responsible for re-evaluating the end product (including the transmitter) and obtaining a separate

FCC authorization.

Any company of the host device which install this modular with limit modular approval should

perform the test of radiated emission and spurious emission according to FCC part 15C:15.247 and

15.209 requirement, Only if the test result comply with FCC part 15.247 and 15.209 requirement,

then the host can be sold legally.

End Product Labeling

If the FCC identification number is not visible when the module is installed insideanother device,

then the outside of the device into which the module is installed must also display a label referring to

the enclosed module. This exterior label can use wording such as the following: Contains Transmitter

Module FCC ID: 2AQ5RNFCB20FDU6.

Manual Information to the End User

The OEM integrator has to be aware not to provide information to the end user regarding how to

install or remove this RF module in the user’s manual of the end product which integrates this

module.

The end user manual shall include all required regulatory information/warning as show in this

manual.

When the module is installed inside another device, the user manual of this device must contain

below warning statements;

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1)

This device may not cause harmful interference.

(2)

This device must accept any interference received, including interference that may cause

undesired operation.