User's Manual

2 3
PREPARATION
CHARGING THE BATTERY PACK
Plug the power adapter into the proper AC wall
outlet; and insert the cable of the power adapter
into the adapter socket on the charger; then the
charger indicator lights green.
Insert the battery or the radio to be charged into
the charger slot.
Make sure the battery is in good contact with the
charger terminals. When the red indicator lights,
the charger begins to charge the battery.
After charging for about 5 hours, the red
indicator turns dim and the green indicator lights
indicating the battery has been fully charged.
Leave the battery in that sate of green indicator for 1~2 hours
before you remove it from the charger to achieve the best
performance of the battery. Then you can disconnect the power
adapter from the AC outlet.
Notes:
* The battery is not fully charged in the factory. Before the initial use,
please charge the new battery.
* The KB-36A Ni-MH battery/KB-36C Li-Ploy battery of Kirisun is
adaptable with this radio.
* When you charge the battery the first time or after long time storage
INSTALLING /REMOVING THE BATTERY PACK
*
Notes:
Do not cause short-circuit or throw the battery to the fire.
Do not disassemble the battery by yourself.
*
Installing the Battery Pack
Match the 3 bulges of the battery pack with the
corresponding slots at the rear bottom of the radio.
Installing the Battery Pack
Then firmly press the battery pack downwards to
lock it in place until a click is heard.
Removing the Battery Pack
To remove the battery pack, use your thumb to
press the belt clip, one side of your index finger to
press the release button and then pull the battery
away from the radio.
(2 months), several times of charging is needed. Make sure the
battery is charged at least once every three months.
* Do not charge the battery again if it is charged fully or not in the low-
pressure warning mode, otherwise, it will have bad effects on its life
and performance. Remove the battery from the charger after charging.
* When you use the KB-36A battery, and the transceiver is in the low-
power warning mode, recharge the battery before use. Do not start up
by force; otherwise, it will have bad effects on its life and performance.
* There is a protection circuit in KB-36C battery, so the power will be
cut off at too low power.