User's Manual

16 17
Emergency Alert
Back light
Rptr/Talkaround
Express select channel 1
Express select channel 2
Call 1, 2, 3 or 4
Channel lock
Adjust display contrast
Man down
Notes:
Programmable key can be set as short press or long press.
The following functions can be programmed by the dealer:
None
Set of None
Scan
Press the button set as Scan to start scanning. When carrier wave
scan is enabled. While in scanning, the radio checks every channel
(any channel in any zone) and stops on the channel on which a
signal is detected until that signal disappears. If interval between
signal disappearing and continuing scanning has been preset, the
radio will remain on that channel. Only when there are two channels
added in the scan list and the scan function has been activated, the
radio can start scanning.
It can be set as: short press: scan, long press OFF.
1. Press the programmable key once to start scanning (it should be
effective in the channel scan list).
2. Press key once again to quit.
Notes:
There are 8 zones from 0 (default zone) to 7; and there can be as
many as 128 channels in each zone. There are totally 16 scan lists;
PROGRAMMABLE BUTTON FUNCTIONS
The dealer can program the 2 Side Buttons and 1 top Button with one
of the following auxiliary functions.
None
OFF ( do not set the functions )
Scan
lone working
Contact list
Power selector
Show or hide the channel alias
Busy Channel Lockout (BCL)
Key lock
Squelch level selector
Companding
Scrambler
Battery power
Zone
Monitoring
Cancel Squelch
P
2
P
3
P
3
P
4
P
4
P
4
P
4
5. Press to enter the wired clone, as shown Programming .
(The two radios should be connected with each other by a clone cable.)
Check the radio information
1. As shown: in CH 1 , press to enter select mode,
2. Press / , and Radio Infor is shown,
3. Press to select,
4. Select Fre Range / MCU Version with / ,
Fre Range indicates the radio frequency range;
MCU Version indicates the radio version.