User's Manual

14
15
1 As shown: in CH 1 , press to enter select mode,
2. Press / , and Ch Edit is shown,
3. Press to select
4. Press , is shown, enter the set of Rx
CTCSS/DCS FRQ
5 Set the Rx CTCSS/DCS value with the keypad,
6. Press to delete, and press to confirm.
7. Stands for the radix point, press to convert among
CTCSS DCS and reverse DCS.
Set Tx CTCSS/DCS
1 As shown: in CH 1 , press to enter select mode,
2. Press / , and Ch Edit is shown,
3. Press to select
4. Press , is shown, enter the set of Tx
CTCSS/DCS FRQ,
5. Set the Tx CTCSS/DCS value with the keypad,
6. Press to delete, and press to confirm.
7. Stands for the radix point, press to convert among
CTCSS DCS and reverse DCS.
Set contact list
1 As shown: in CH 1 , press to enter select mode,
2. Press / , and Contact List is shown,
3. Press to select,
4. Select the address cable of the call to be made with / ,
5 Check the alias or address code by turning the knob,
P
2
P
3
P
4
P
4
P
2
P
3
Ch alias
CHANNEL 1
P
2
P
3
P
4
Tx CTCSS
XXXX
P
3
P
4
P
1
*
Rx CTCSS
OFF
Ch alias
CHANNEL 1
P
2
P
3
P
3
P
4
P
4
*
P
4
P
1
P
4
6. Key in the address code of the person you are calling,
7. Press to transmit the current contact list.
Set status:
1 As shown: in CH 1 , press to enter select mode,
2. Press / , and Status is shown,
3. Press to select,
4.Select the needed status with / ,
5. Check the alias or address code of the status by turning the knob,
6. Press to select the current status.
P
4
P
2
P
3
P
4
P
4
P
4
P
2
P
3
P
4
P
2
P
2
P
2
P
2
P
3
P
3
P
3
P
3
P
3
P
4
P
4
P
4
P
4
P
4
P
4
P
4
P
4
Set wireless clone
1. As shown: in CH 1 , press to enter select mode,
2. Press / , and clone mode is shown,
3. Press to select wireless clone or wired clone, e.g.,
Wireless clone / wired clone
4. Select the wireless clone with / , e.g., Wireless clone
5. Press to select the clone frequency point, as shown 438 Mhz .
It can be changed with / .
6. Press to select Tx or Rx mode, e.g., Send Mode / Receive Mode
7. Press to transmit in Tx Mode, as shown Transmitting
8. Press to receive in Rx Mode, as shown Receiving
Note: one radio should enter the Receiving , and then the other one
can enter Transmitting .
Set wired clone
1. As shown: in CH 1 , press to enter select mode,
2. Press / , and clone mode is shown,
3. Press to select wireless clone or wired clone, e.g.,
Wireless clone / wired clone
4. Select the wired clone with / , e.g., Wired clone