User's Manual Part 1

seconds, and turn on the transceiver at the

same time entering Clone Mode.

1) When the clone slave

s entering clone mode, LED lights

orange and you will hear voice annunciation

Clone .

When release buttons, voice annunciation Channel 1

sounds.

2) When the Clone master entering clone mode, LED lights

orange and you will hear voice annunciation

Clone .

When release buttons, voice annunciation Channel 1

sounds.

3) Select on the Clone master the channel number identical

with that on the Clone slave

s. You can select clone channel

by pressing Side Button 1 or Side Button 2.

4) Press the PTT button on the Clone master to

transmit data and LED flashes red.

The Clone Slave

s begins to receive cloning data and

LED

lights green.

When the data transfer is completed, the Clone

master sounds confirming beep.

5) After the data transfer the Clone master cannot be set as

Clone Slave to receive data form other transceivers.

6) The cloning rate has been automatically set at

a low value 1200bps.

6.8 Emergency Alert

If Emergency Alert has been set on the

transceiver by programming, you can make emergency calls.

1) Press and hold the emergency alert button.

According to the delay time preset on the

transceiver, the