User's Manual Part 2

dealer, and you have to be equipped with the

specified headset earphones.

Before using VOX, you must set VOX gain level. Such setting

enables the transceiver to identify the voice volume.

If the microphone is too sensitive, the background noise will

trigger the transceiver to transmit. If the microphone is not

sensitive enough, it cannot receive your voice when you

speak. Make sure to adjust VOX gain level to proper

sensitivity.

1) Connect the headset earphones with the transceiver.

2) Turn off the transceiver, and then turn it on

again and press Side Button 1 at the same time.

3) Hold Side Button 1 till a beep sounds and

LED lights orange, then release Side Button 1, and

the transceiver will announce VOX gain level.

4) Press Side Button 1 to increase VOX gain level;

press

Side Button 2 to decrease it.

VOX gain level can be adjusted between level 1 ~10 and OFF.

When adjusting gain level, the transceiver will announce VOX

gain level. If OFF is selected, beep tone will sound.

5) Press PTT to store the setting. After a

beep, the transceiver announces new VOX gain level.

6) Turn off the transceiver, and turn it on again,

and then

VOX function is activated.

6.7 Wireless Clone

The dealer can enable or disable this

function by programming.

clon

programmin

dat

fro

Button 2 for 2