User's Manual Part 2

2) Transmitting Signal:
If the PTT ID on the channel you select has been set with 5
8 TROUBLESHOOTING
Tome, 5 Tone signal will be transmitted when making a call.
No. PROBLEM SOLUTION
Or transmit 5 Tone signal by pressing CALL1 or
CALL2
button, which can be set by the dealer.
7.13 Transmitting Beginning/Ending Signaling
1) Transmitting Beginning/Ending signaling is used to
join in or disconnect from some repeaters and telephone.
2) Transmitting Beginning signaling is used to join
in the conventional repeater and its relevant auxiliary
equipments. If the ID being transmitted matches with the
repeater's ID, it can use the repeater and its auxiliary
equipments.
3) Transmitting Ending signaling is used to
disconnect with the conventional repeater and
its relevant auxiliary equipments. If the ID being
transmitted matches with the repeater's ID, it can
disconnect from the repeater and its auxiliary
equipments.
The transceiver
cannot be switched
1
on or no display
after switched on.
The battery power
2 consume quickly
after charging.
3 Cannot talk to or
hear other members
in your group.
Other voices from
4
non-group members
are heard on the
channel.
Battery pack may not be installed
properly. Remove the battery pack
and install it again.
Battery power may be insufficient.
Recharge or replace the battery pack.
The battery life is finished, please
replace it with a new battery pack.
The frequency or CTCSS/DCS
signaling is not identical and please
reset it.
Not receive the correct DTMF, KDC
1200,2-Tone and 5-Tone signaling or
the effective time expires.
Beyond the transceiver efficient com-
munication range.
Change the CTCSS/DCS tone, and
make sure change the tone on all
transceivers in your group.
Please set DTMF, KDC1200, 2-Tone
or 5-Tone selective signaling on the
channel.
2
3
24