User Manual

10
Whisper
After you press the button set as “Whisper”, your counterpart can hear louder voice even you
speak in a very low voice; press it again to exit.
VOX (Voice-operated transmission)
Press the button set as “VOX” to enter the voice operated mode and you can talk with your
counterpart without pressing the PTT button.
Battery Power Indication
When you press the button set as “Battery Power Indication”, indication tone “1”, “2” , “3” or “4”
sounds to indicate the current battery power.
Temporary Activation of Channel Annunciation
When you press the button set as “Temporary Activation of Channel Annunciation”, one of the
following situation occurs:
a. If the current channel number sounds at the beginning:
Press the button set as “Temporary Activation of Channel Annunciation” to sound two beeps to
temporarily cancel the channel annunciation function; you still can hear the channel number
annunciation after turning on the radio again.
b. If the current channel number doesn’t sound at the beginning:
Press the button set as “Temporary Activation of Channel Annunciation” to sound one beep to
temporarily activate the channel annunciation function; you won’t hear the channel number
annunciation after turning on the radio again.
Activation of Channel Annunciation
When you press the button set as “Activation of Channel Annunciation”, if the radio sounds two
beeps, it cancels the channel annunciation function; you won’t hear the channel number
annunciation after turning on the radio again.
When you press the button set as “Activation of Channel Annunciation”, if the radio sounds one
beep, it activates the channel annunciation function; you can hear the channel number
annunciation even after turning on the radio again.
Reverse Frequency
Press the button set as “Reverse Frequency” to activate the reverse frequency function.
■ Wired Cloning Mode
If the wired cloning mode has been set, the radio won’t exit automatically after it entering the
wired cloning mode. To return to the user mode, you need to turn on the radio again.
Wired cloning procedures are as follows:
1) Press and hold the Side Button 2 on the host radio while turning on the radio; about 2 seconds
later, two short beeps sound and red indicator flashes, and the radio enters cloning mode.
2) Press once the PTT button on the host radio, and then the sub radio to receive data will enter