User's Manual

2
14
No power
Battery power
dies shortly
after charging
Can not talk to
or hear other
members in
your group
Make sure you are using the same
frequency and quiet talk tone as the
other members in your group.
Other group members may be too
far away . Make sure you are within
the range of the other transceivers.
NO.
PROBLEM
SOLUTION
MONITOR
When there is no signal received , the squelch
circuit on the transceiver automatically mutes
the speaker, so you will not hear background
noise. To manually deactivate the squelch,
press the Monitor key, which is useful when you
want to adjust the volume level or when you
need to receive a weak signal.
QUIET TALK (QT) & DIGITAL QUIET TALK (DQT)
1. Some channels may have pre-programmed
QT/DQT tones. A QT/DQT tone is a subaudible tone
which allows you to ignore(not hear)calls from
other parties who are using the same channel.
2. When you receive a signal that has a tone
different from the one set in your transceiver,
you will not hear the signal. Likewise, signals
that you transmit will only be received by parties
whose QT/DQT tones as the same as yours.
Note : Though you use a QT/DQT channel which can
prevent you from receiving unwanted signals,
it does not mean your calls will be private.
TROUBLESHOOTING GUIDE
1) The battery pack may be
dead. Recharge or replace
the battery pack .
2) The battery pack may not
be installed properly. Remove
the battery pack and instal l it
again .
The battery pack life is
finished .Replace the battery
pack with a new one .
Other voices
(besides group
members) are
on the channel.
Change the Quiet Talk tone.
Be sure to change the tone on
all transceivers in your group .
2
15