User's Manual

REMARKS:
The above mentioned currently working channel
means the channel in which the transceiver holds
on under the following four conditions.
2) When receiving signals during scan, the
transceiver will pause and stay in current
channel for 3 seconds after the signals
disappear.
3) Transceiver will stay in current channel when
pressing PTT during scan.
4)The transmitting will end by releasing PTT,
Within the transmitting pause time preset by
local distributor ,the transceiver will stay in
current channel.
AUXILIARY FUNCTIONS
TIME-OUT- TIMER
The purpose of the Time -out -Timer is to prevent any single
person from using a channel to transmit for an extended
period of the time. If you continuously transmit for 10 minutes,
the transceiver will stop transmitting and a tone will be
heard. To stop the tone , release the PTT switch. You can
press the PTT again t o resume transmitting .
B ATTERY SAVING
The Battery- Saving function decreases the power
consumption when no signal being received or no
operations being performed (no keys are being pressed ,
and no switches are being turned .)
L OW BATTERY WARNING
Low battery warning alerts you, when the battery need s to
be recharged while transmitting. If the battery power goes
below a certain value , the LED light will blink red, and the
transceiver will stop transmitting .¡£
2
*
12
2
13
SELECTED CHANNEL :
The first channel in the scanning list set by
distributor.
PRIOR CHANNEL:
The prior channel in the scanning list set
by distributor.
*
1) Before restarting the scan after receiving the
signals, the transceiver still stay in current
channel.