User's Manual

- 9 -
3 Basic Operation
3.1 Power on /off Transceiver
When the transceiver is off, press the power switch
to power it on. When the indicator
glows,
the system starts to operate, and the indicator
or will indicate the default work mode. Press
the power switch
to power off the transceiver when it is on.
3.2 Connect to the Controller
After connected with the controller, the indicator
glows. The indicator is flashing while
sending to the controller, and
is flashing while the controller is sending to the transceiver.
3.3 Voice and Data Transmission
While the transceiver is sending voice or data to the air interface, the indicator TX-A and TX-B are
flashing. If some MS sends data on time slot 1, RX-A flashes, sends data on time slot 2, RX-B flashes.
3.4 IP Interface
Default IP address: 192.168.1.100. You can upgrade software, configure the programming parameters
and perform extended development through this interface.