Instruction Manual
25
time, the transport mode needs to be deactivated to restore the vehicle to normal.
3.4.20 A/F Reset
This function is applied to set or learn Air/Fuel ratio parameters.
3.4.21 Stop/Start Reset
This function is used to open or close the automatic start-stop function via setting the hidden function in
ECU (provided that the vehicle has a hidden function and supported by hardware).
3.4.22 NOx Sensor Reset
NOx sensor is a sensor used to detect the content of nitrogen oxides (NOx) in engine exhaust. If the
NOx fault is re-initialized and the NOx catalytic converter is replaced, it is necessary to reset the catalytic
converter learned value stored in the engine ECU.
3.4.23 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
After the diesel exhaust treatment uid (car urea) is replaced or lled up, urea reset operation is required.
3.4.24 Seat Calibration
This function is applied to match the seats with memory function that are replaced and repaired.
3.4.25 Coolant Bleeding
Use this function to activate the electronic water pump before venting the cooling system.
3.4.26 Tyre Reset
This function is used to set the size parameters of the modied or replaced tire.
3.4.27 Windows Calibration
This feature is designed to perform door window matching to recover ECU initial memory, and recover the
automatic ascending and descending function of power window.
3.4.28 Language Change
This function is used to change the system language of the vehicle central control panel.
3.4.29 AC System Relearn/Initialization
If the ECU or actuator of the vehicle air conditioner is replaced, or the memory of the ECU memory is lost,
air conditioner initialization learning is needed.
3.4.30 Intelligent Cruise Control System
For replacement of intelligent cruise control system of vehicle and matching after repairing.