Instruction Manual
8
OBD I Connector
OBD I Transfer Cable
OBD Connector
Transfer process
Note: when using older models, the Transfer Cable must be used, with the small power connector on it, which is
connected to the power connector of the power double clamp cable, this is a solution for certain cars before 1996,
whose diagnostic holders do not have a 12V power supply.
Application of the double clamp power cable
All other congurations with Non 16-PIN diagnostic connectors can be wired as shown in Picture 5 for
achieving the diagnosis of the corresponding old models.
1.7 Scope Box / Video Scope / Printer Installation
The Scope Box and Video Scope are connected by USB cable. It will automatically enter the
corresponding interface once they are connected.
！