Instruction Manual

5
1.4 Charging
Follow the steps below to charge the device:
• Use the charger to connect the device and the power socket to charge.
• When the battery status displays , the device is charging.
When it displays , the charging process has been completed and you shall disconnect the device.
1.5 Battery
• It is normal that the device cannot be turn on when charging because the battery has not been used for
a long time or maybe the power is exhausted. Please turn on the device again after charging the battery
for a while.
• Please use the charger in the package to charge the device. Except for the chargers specied by the
company, the company shall not be liable for any damage and loss caused by charging with other
chargers.
• The battery can be recharged repeatedly. Please try not to recharge frequently to avoid battery loss and
prolong battery life.
• The battery charging time varies with temperature and battery status.
• When the battery power is low, the system will pop up a prompt to remind you to connect the charger.
When the battery power is too low, the device will turn o󰀨.
1.6 VCI Connections
Connection steps as below:
(1) Locate vehicle’s DLC socket. Most of the DLC are standard OBDII/EOBD diagnostic sockets (non-
standard OBDII/EOBD vehicle diagnostic sockets need to use the corresponding adapter). The DLC
is usually located 12 inches from the center of the instrument panel (dash), under or around the
driver’s side for most vehicles. If the DLC cannot be found, refer to the vehicle’s service manual for the
location.
A Opel, Volkswagen, Audi
B Honda
C Volkswagen
D Opel, Volkswagen, Citroen
E Changan
F
Hyundai, Daewoo, Kia, Honda, Toyota, Nissan,Mitsubishi,
Renault, Opel, BMW, Mercedes-Benz, Mazda, Volkswagen,
Audi, GM, Chrysler,Peugeot, Regal, Beijing Jeep, Citroen and
most prevailing models
(2) For OBDII/EOBD vehicle, follow the steps below to proceed:
a. Plug the VCI dongle into the vehicle’s DLC socket
b. Use the OBDII/EOBD extension cable to connect the VCI dongle and DLC socket.