Installation Instructions

Temperature accuracy:±3℃
working temperature:-40℃-105℃
working frequency:315MHZ
Product weight:21.8g
Operation steps:
1. Before the sensor is installed, it should be programmed with ateq tool according to
the model year;
2. Install it on the wheel hub according to the following figure:
Select the direction suitable for the angle and screw on the air nozzle nut
Keep the white surface of the sensor parallel to the wheel hub surface, and tighten
the air nozzle nut with 8nm torque Tire power balance
Installation precautions:
1. The valve should not extend out of the rim
2. The sensor shell shall not interfere with the wheel rim
3. The white surface of the sensor shall be parallel to the rim surface
4。 The sensor housing must not extend beyond the rim flange