User's Manual

Check the follows before requesting service:
SYMPTOM POSSIBLE CAUSE
No power AC/DC Adaptor had not
wall outlet
POWER Switch is in OFF
position
on
the rear of unit to ON
position
The unit in standby mode Press and hold the
(Standby) Button on the unit
2 seconds then
release the button or Press
the
(Standby) Button on
the Remote Control to turn
on the unit from standby
mode
No Sound Volume in minimum position Rise volume level by press
the
The connected device is
not
in playback mode
Plays the music/movie in
the
connected
device as usual
Sound output of the
weak
Rise the volume level of the
device
Input source incorrect
Sound distortion Volume level too high
press the
Volume level of the
connecte
device too high the connected device
BT not functioning
The external BT device too
far from the unit
Place the external BT
device close to the unit
Remote not
functioning
The button cell in the remote
control consumed
Replace it by new button cell
Set the input source as t
Reduce the volume level by
POSSIBLE SOULTION
VOL (Volume) +
Button
VOL (Volume) - B utton
Reduce the volume and/or bass
level of
12
connect to and unit
Connect the AC/DC Adaptor to
the wall outlet and unit
Slide the POWER ON/OFF Switch
approximately
/paird
/paird
connected
/paird
device
connected
/paird
source
paird
/paird
The external BT device had
not pair to the unit
Pair the external BT device to the
unit as page 9
7528%/(6+227,1* *8,'(
he desired
d/