User's Manual

DANGEROUS VOLTAGE: The lighting flash with arrowhead symbol

within an equilateral triangle is intended to alert the user to the

presence of uninsulated “dangerous voltage” within the product’s

enclosure that may be of sufficient magnitude to constitute a risk of

electric shock

to persons.

ATTENTION:

The exclamation point

within

an equilateral triangle is intended

to alert the

user

to the presence

of important operating and maintenance

(servicing) instructions in the literature accompanying the appliance.

FCC NOTICE:

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

CAUTION: TO REDUCE THE ELECTRIC SHOCK, DO NOT REMOVE THE

COVER (OR BACK). NO USER SERVICEABLE PART INSIDE, REFER

SERVICING TO

UALIFIED SERVICE PERSONNEL.

RISK OF ELECTRIC SHOCK

O NOT OPEN

CAUTION

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

FCC STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference

that may cause undesired operation. Changes or modifications not

expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.