User's Manual

7
BATTERY INSTALLATION
- Before installation
Remove and discard the insulation tab. Out of the box the Remote Control has a battery and will
be usable after the tab is removed.
- How to replace battery for the remote control
1. Push and slide out the battery holder as shown below.
2. Replace the battery with a new CR2025 button cell with the polarity (+) side upward.
3. Slide the battery holder back into the remote control.
Battery precautions
 Never recharge the batteries, apply heat to them or take them apart.
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
 Do not throw the batteries in fire!
 Attention should be drawn to the environmental aspects of battery disposal.
 If the remote control is not going to be used for a long time, remove the battery
to avoid damage caused by battery leakage corrosion.
POWER CONTROL
- To turn the unit ON
· Connect the supplied AC/DC adapter.
· Press the STANDBY button to turn ON the unit.
- To turn the unit OFF
· Press STANDBY button on the remote control or hold STANDBY button on the front of the unit.
NOTE:
If the unit is not used for a long period of time, disconnect the power adapter.
TIME SETTING
1. Switch the unit to standby mode.
2. Hold CLOCK/MO/ST button on the remote control until the hour digit flashes.
3.Then press TUNE+ or TUNE- button on the unit or remote control to adjust the hour.
4. Press CLOCK/MO/ST button on the remote control to confirm the hour setting and the minute
digit will flash.
5. Then press TUNE+ or TUNE- button on the unit or remote control to adjust the minute.
6. Press CLOCK/MO/ST button on the re
mote control to confirm the minute setting.
NOTE:
When disconnecting the power adapter, the setting will be canceled. Time has to be reset next time.
FM RADIO
Power ON the unit and press the SOURCE button until the FM frequency appears on the disp
lay.
- Search and store the stations
1. Hold TUNE+ or TUNE- button to search through stations forward or backward. The unit will
stop if a station is found. Then press FM SCAN button, “CH XX” will flash and then use M+
button to select the place you want the station stored to. Press FM SCAN button to confirm. Or;
2. Hold FM SCAN button then release. The unit will search and store the stations automatically.
- Listen to the preset stations
Press M+ button repeatedly to select the desired
preset stations to listen to.
NOTE:
If the received FM stations are in stereo mode, the unit will play in stereo mode automatically. If
reception is weak, press the CLOCK/MO/ST button to turn the unit to mono mode. Press again to
turn to stereo mode.