User's Manual

on main unit repeatedly to select the Bluetooth mode, the Mode Indicator LED turns

blue and begins flashing

3. After the Bluetooth device is paired with the JSBW-650, wait for around 5 seconds

and then press the PLAY/PAUSE

button on remote control to start music

playback from your cell phone or Bluetooth device.

4. Press the PLAY/PAUSE

button to pause or resume playback.

5. Press the VOLUME+/- button to adjust your desired volume level

6. If necessary, press the TREBLE or BASS +/- buttons on the remote control to adjust

the separate treble and bass levels.

7. Press the

or button on the remote to select the desire music track.

8. Press the

POWER button on remote control or press and hold the button on

main unit to turn off the unit after listening.

Re-linking to a cell phone or Bluetooth device

If your cell phone or Bluetooth device is already paired with the JSBW-650, but became

unlinked at some point, even with both Bluetooth devices turned on. You can re-link

them by:

1. Press and hold the PAIR button to re-link your cell phone. The Mode Indicator LED

will turn blue and flash while linking.

2. Select the JSBW-650 from the devices list on your cell phone for linking. The Mode

Indicator LED stops flashing and remains lit blue if the JSBW-650 and your cell

phone have been re-linked successfully.

3. You can also re-link the JSBW-650 by using Bluetooth operation of your cell phone.

Please refer to operation manual of your cell phone for more information.

PRESET EQ (REMOTE CONTROL ONLY)

The JSBW-650 features 5 different EQ modes to enhance your listening experience.

You can select the desired effect by pressing the “EQ” button on remote control

repeatedly at following sequence:

NORMAL

JAZZ

POP

CLASSIC ROCK

In addition, you can adjust treble and bass effects by using the TREBLE & BASS

+/- buttons.

NOTE:

1. Press and hold the EQ Button for 5 seconds to reset the EQ to the default

(NORMAL) setting. BASS and TREBLE settings will also be reset to the center

position.

2. If you press the BASS or TREBLE buttons (+ or -) while listening, the EQ will reset

to the default (NORMAL) setting to allow you to increase or decrease the BASS and

TREBLE as needed.