User's Manual

LISTENING TO THE FM RADIO

TUNING THE FM RADIO

1. Press the

POWER button to turn on the unit.

2. Press the SOURCE button on remote control or tap the

/SOURCE button on

main unit repeatedly to select FM radio mode, the Mode Indicator LED turns to

purple color.

3. To manually tune a radio station, press the TUNE + / TUNE - button on

the remote control repeatedly to change stations. Use the manual tuning method to

tune to weaker stations that are occasionally skipped during Automatic Tuning.

4. To automatically tune to the next radio station with the strongest signal, press and

hold the

/ button on the remote for 1-2 seconds until the purple FM

indicator begins to flash. Release the button or tap the TUNE + button on main unit.

The tuner will stop scanning when it receives the next strongest station signal.

5. Press the VOLUME +/- button to adjust the volume control to the desired level.

6. If necessary, press the EQ to select one of the preset EQ settings or the TREBLE

and BASS +/- buttons on the remote control to adjust the separate treble and bass

levels.

FM & FM-Stereo reception

- When listening to the FM radio, press the FM MO/ST (MONO/STEREO) button to

switch between stereo mode and mono mode. It is preferable to receive the

program in mono when you are receiving a weak station.

HINTS FOR BEST RECEPTION:

To obtain the best FM/FM Stereo reception, unwrap and fully extend the FM

Antenna and adjust the position of the wire for best station reception

NOTE: Automatic tuning depends on the signal strength of the broadcasting station, so

weak stations may be skipped. You can manually tune to find the weak stations

if a station gets skipped. With strong signals, the tuner may stop before it

reaches the actual broadcast frequency, so you may need to manually tune for

the best reception.

NOTE:

1. Press and hold the EQ Button for 5 seconds to reset the EQ to the default

(NORMAL) setting. BASS and TREBLE settings will also be reset to the center

position.

2. If you press the BASS or TREBLE buttons (+ or -) while listening, the EQ will reset

to the default (NORMAL) setting to allow you to increase or decrease the BASS and

TREBLE as needed.