Safety Information

7
f ) When the product exhibits a distinct
change in performance-this indicates a
need for service.
25 ) Note to CATV system installer
This reminder is provided to call the CATV
system installer's attention to Article 820-
40 of the NEC that provides guidelines
for proper grounding and, in particular,
specifi es that the cable ground shall be
connected to the grounding system of the
building, as close to the point of cable
entry as practical.
NOTE: Refer all servicing to qualifi ed
service personnel servicing is required
when the unit has been damaged in any
way such as the following: the power
supply cord or plug has been damaged,
liquid has been spilled into unit, the unit
has been exposed to rain or moisture, the
unit has been dropped or the unit does
not operate normally.
IMPORTANT SAFETY INSTRUCTIONS
NOTES ON HANDLING:
●
When shipping the unit, always use the
original shipping carton and packing
materials. For maximum
protection, repack the unit as it was
originally packed at the factory.
●
Do not use volatile liquids, such as
insect spray, near the unit. Do not
leave rubber or plastic products in
contact with the unit for a long time.
They will leave marks on the fi nish.
●
The top and rear panels of the unit
may become warm after a long period
of use. This is normal and not a
malfunction.
●
When the DVD player is not in use, be
sure to remove the disc and turn off
the power.
NOTES ON LOCATING THE DVD
PLAYER:
When you place this unit near a TV, radio
or VCR, the playback picture may become
poor and the sound may be distorted. In
this case, move the unit away from the
TV, radio or VCR.
NOTES ON CLEANING:
Use a soft, dry cloth for cleaning
●
For stubborn dirt, soak the cloth in a
weak detergent solution, wring well
and wipe. Use a dry cloth to wipe it
dry. Do not use any type of solvent,
such as thinner and benzene, as they
may damage the surface of the unit.
●
If you use a chemical-saturated cloth
to clean the unit, follow that product's
instructions.
Warning: Cleaning and adjustment of
lenses and/or other components of
playback mechanism should be performed
by a qualifi ed service technician.