User's Manual

BATTERY INSTALLATION ( REMOTE CONTROL)
---First time using
Remove and discard the insulation tab as the figure on right.
----Replacing battery for remote control
1. Push and slide out the battery trap as the figure below and the rear of the remote
control.
2. Replace the battery by a new CR2025 button cell with the polarity “+” facing up as the
figure below and the rear of remote control.
3. Close the battery tray.
BATTERY PRECAUTIONS
Follow these precautions whe n using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the
battery compartment, a reserve d battery may cause damage t o the device.
3. Do not mix different types of batteries together ( e.g: Alkaline and Carbon-zinc ) or old
batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long
period of time, remove the batteries to prevent damage or injury from possible leakage.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and
rupture. ( Follow battery manufacturer’s instructions.)
6. The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
7. Clean the battery contacts and also those of the device prior to battery installation.
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD.
The remote control supplied with a c oin/button cell battery. If the coin button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used battery away from children. If the battery compartment does not close
securely, st op using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body,
seek immediate medical attention.
CAUTION!
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type.