Glitter Lamp Bluetooth Speaker MODEL:ITSBL-509 PLEASE READ CAREFULLY BEFORE OPERATING THIS EQUIPMENT KEEP IT IN A SAFE PLACE FOR FUTURE REFERENCE
IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER SERVICEABLE PART INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
FCC NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
6. Clean only with dry cloth The appliance should be cleaned only as recommended by the manufacturer. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Slots and openings in the cabinet and in the back or bottom are provided for ventilation, to ensure reliable operation of the product and to protect it from overheating. These openings must not be blocked or covered.
on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For products intended to operate from battery power, or other source, refer to the operation instructions. 16. Power lines An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits.
BE SURE TO READ AND KEEP THIS INSTRUCTIONS CARE AND OPERATION: The lamp speaker is designed to operate in an average room temperature of 22-25℃, make sure the lamp speaker is at room temperature before starting. Always operate the unit on a firm, flat and stationary surface. Do not operate the lamp speaker on any warm or hot surfaces. CAUTION: ●The lamp speaker should never be operated for more than 24 hours at a time. If operated for more than 24 hours, the base can get deformed from heat.
DANGER! ●Do not replace with unauthorized bulb in this lamp speaker. ●The lamp and speaker base will be hot while in use and after the unit has been turned off/unplugged. Do not touch the lamp speaker or the bulb while it is on. ●Keep it out of the reach of the children and pets. ●Do not take the glass vessel out although it can be taken out from the speaker base! ●Do not put your fingers into the bulb cave, it is very hot, the temperature can reach up to above 100 ℃ .
PRODUCT OVERVIEW 1. 2. 3. 4. 5. 6. 7. 8.
BLUETOOTH OPERATION 1. Plug the power plug into the wall outlet with power supply 120V~,60Hz. 2. Push the power switch on AC cord to "ON" position. 3. Press and hold the button on the speaker for seconds to power on the unit. The Bluetooth indictor will illuminate and flash blue, now the speaker is in pairing mode. 4. Activate the Bluetooth on external Bluetooth device and try to search the speaker, the pairing name "ITSBL-509 " will appear on pairing list, select it and try connection. 5.
TROUBLESHOOTING GUIDE Check the following before requesting service: SYMPTOM Can’t power on No sound or sound weak Sound distortion BT not f unctioning POSSIBLE CAUSE Power switch is on"OFF" position POSSIBLE SOLUTION Push the power switch to "ON" position.
WARRANTY 11
