EMERSON BLUETOOTH SPEAKER Model:EBT1100
Safety Instructions -The lighting flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. -The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
FCC Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Product Overview 1 Built-in microphone 2 Volume up button 3 Next button 4 Play/Pause/Standby button 5 Volume down button 3 6 Bluetooth/Battery indicator 7 Previous Button 8 USB charging port 9 AUX IN jack
Charge Battery The device is operated via the integrated lithium battery. Charge the battery as followings: 1.Plug the micro B USB plug of the charging cable into the jack of the device. Connect the USB plug to a powered-on computer. The indicator lights up red and the battery begin to charge. 2.If the battery is completely charged, the indicator red light turns off. 3.Remove the charging cable from the Speaker and PC.
For this, refer to the operation manual of your player. The Device “EBT1100” will show in your player as a selection. 4. If the playback device was recognized,The Bluetooth indicator will blink slowly. After successful registration, the Bluetooth indicator will stop flashing. Note: -Depending on the device manufacturer, you need to perform the registration (PAIRING) again to connect the devices.
Troubleshooting Symptoms Cannot switch the Speaker Possible cause Solution Battery exhausted Charge the battery. No audio signal during Volume of the external audio Increase the volume of the playback through AUX. source is too low. external audio device. Volume of the device too low Increase the volume with + on. button No audio signal during Speaker is switched off. Switch the Speaker on. Bluetooth connection. Speaker is not paired to the Check whether the audio device.
Technical Specifications Audio output .....................................................................................................................1W x 2 Power supply:...................................................................................................................DC 5 V Battery:..............................................................................................3.7V,400mAh Lithium-lons Operating time:.........................................................................
