User's Manual
Table Of Contents
- User Manual_页面_01
- User Manual_页面_03
- User Manual_页面_04
- User Manual_页面_05
- User Manual_页面_06
- User Manual_页面_07
- User Manual_页面_08
- User Manual_页面_09
- User Manual_页面_10
- User Manual_页面_11
- User Manual_页面_12
- User Manual_页面_13
- User Manual_页面_14
- User Manual_页面_15
- User Manual_页面_16
- User Manual_页面_17
- User Manual_页面_18
- User Manual_页面_19
- User Manual_页面_20
- User Manual_页面_21
- User Manual_页面_22
- User Manual_页面_23
- User Manual_页面_24
- User Manual_页面_25
- User Manual_页面_26
- User Manual_页面_27
- User Manual_页面_28
- User Manual_页面_29
- User Manual_页面_30
- User Manual_页面_31
- User Manual_页面_32
- User Manual_页面_33
- User Manual_页面_34
- User Manual_页面_35
- User Manual_页面_36
- User Manual_页面_37
- User Manual_页面_38
- User Manual_页面_39
- User Manual_页面_40
- User Manual_页面_41
- User Manual_页面_42
- User Manual_页面_43
- User Manual_页面_44
- User Manual_页面_45
- User Manual_页面_46
- User Manual_页面_47
- User Manual_页面_48
- User Manual_页面_49
- User Manual_页面_50
- User Manual_页面_51
- User Manual_页面_52
- User Manual_页面_53
- User Manual_页面_54
- User Manual_页面_55
- User Manual_页面_56
- User Manual_页面_57
- User Manual_页面_58
- User Manual_页面_59
- User Manual_页面_60
- User Manual_页面_61
- User Manual_页面_62
- User Manual_页面_63
- User Manual_页面_64
- User Manual_页面_65
- User Manual_页面_66
- User Manual_页面_67
- User Manual_页面_68
- User Manual_页面_69
- User Manual_页面_70
- User Manual_页面_71
- User Manual_页面_72
- User Manual_页面_73
- User Manual_页面_74
- User Manual_页面_75
〈《
S
HE
N
ZHE
N J
UM
P
E
R T
E
C
H
N
O
L
O
G
Y
C
O
.,LTD
1
0
1, 1
0
2, 2
0
1, 3
0
1 No.13-2 Pingxi South Rd.,
Pingxi Community, Pingdi Street, Longgang
District, Shenzhen, GuangDong
FCC Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Specific Absorption Rate (SAR) information:
This Laptop meets the government's requirements for exposure to radio waves. The
guidelines are based on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of scientific studies. The
standards include a substantial safety margin designed to assure the safety of all
persons regardless of age or health. FCC RF Exposure Information and Statement
the SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device
types: Laptop has also been tested against this SAR limit. This device was tested for
typical body-worn operations with the back of the Laptop kept 0mm from the body.
To maintain compliance with FCC RF exposure requirements, use accessories that
maintain an 0 mm separation distance between the user's body and the back of the
phone. The use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure requirements, and should be
avoided.