Installation Instructions

4 feet
120mm
- 9 -
3
Select a location for your video doorbell.
Determine the mounting position of the doorbell. Check if you can reuse the existing holes on the wall. If not
drill new holes to mount your video doorbell.
It is suggested to mount the doorbell at least 4 feet (120 cm) above the ground for optimal angle of view
and best motion detection performance.
2
Bypass your indoor chime with provided jumper.
In most cases, the existing doorbell circuit looks similar to the image below. Remove the cover of the indoor
chime and loosen the “
FRONT ” and “ TRANS ” terminal screws. Use the provided jumper to connect the two
terminals, and replace the chime cover.
To replace your existing doorbell and mechanical chime, please follow below installation steps:
1
Shut off the master circuit breaker in your house.
10.1 Retro-fit installation (Optional)
Existing Doorbell Button Doorbell TransformerExisting Mechanical Chime
FRONT TRANS REAR