Installation Instructions

Table Of Contents
8
使件/附
J1
线
广 西
1511
Smart Music Glasses
Model: J1
Shenzhen Joint Online Technology Co., Ltd
1-1511, Tangdong photoelectric building,
Hangchen g Avenue, Gushu community,
Xixiang Street, Bao 'an district, Shenzhen
City, Guangdong Province
9. WARNING: Only use attachments/accessories specified or provided by
the manufacturer (such as the exclusive supply adapter, battery etc).
10. CAUTION for service personnel: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or equivalent
type.
11. WARNING: Attention should be drawn to environmental aspects of battery
disposal.
12. WARNING: The batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
13. WARNING: The batteries (battery pack or batteries installed) are not
intended to be replaced by the USER.
FCC Instructions:
This product has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This product generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If the product does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the product and receiver.
-Connect the product into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the product.

Summary of content (1 pages)