User's Manual

Product Parameters
Product Name: Smart Waist Massager
Product model: SM918
Charging current: 1A
Charging voltage: 5V⎓
Battery capacity: 2000mAh
Rated power: 5 W
Rated time: 15 minutes
Charging time: about 2.5 hours
Working temperature: 0 ~ 40 ℃
Product net weight: about 286 g
Product size: 200mm * 95.5mm * 40mm
Executive standard: GB4706.1-2005 GB4706.10-2008
Instructions
1. Connect the USB cable to 5V voltage, and then insert the type-c plug of the cable
into the host. When charging, the white LED indicator is a breathing light effect,
and the white LED is always on when it is fully charged. Make sure that the built-in
battery has enough power to proceed to the next step.
2. Put on the massager with the electrode piece close to the waist or abdomen skin
(do not use it through clothes). Fasten the left and right buckles, and properly
adjust the position of the buckles so that the elastic band is not too tight or too
loose.
3. Long press the power button of the host to make the host enter the startup state.
After startup, the following settings are available:
① Automatic combination mode
② Massage intensity of gear 0
③ Red light is off by default
④ Heating is off by default
⑤ Timing for 15 minutes
4. The remote controller can adjust the intensity, temperature, red light and mode
of the product.
5. Pulse strengthening or weakening key: to increase or weaken the pulse
strength. The strength will change by 1 gear each time the key is pressed. The pulse
strength will change by 8 gears in total. The default gear is 0 when the key is started
(the voice will be broadcast once each time the key is pressed).
6. Mode switch key: press once to switch the mode, and switch among 5 modes
cyclically (mode 1: massage mode, mode 2: knock mode, mode 3: scraping mode, mode
4: vitality mode and mode 5: automatic combination mode). The default automatic
combination mode is started. When switching the mode, the massage force of the
product will return to 0 (once pressed, the voice will be broadcast once).