User's Manual

BL-62B WIFI+BLE module

Page 1 of 13

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and

2) This device and its antenna(s) must not be co‐located with any other transmitters except in

accordance with FCC multi‐transmitter product procedures. Referring to the multi‐transmitter

policy, multiple‐transmitter(s) and module(s) can be operated simultaneously without C2P.

3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G

band by supplied firmware programming tool. OEM shall not supply any tool or info to the end‐user

regarding to Regulatory Domain change.

USERS MANUAL OF THE END PRODUCT:

In the users manual of the end product, the end user has to be informed to keep at least 20cm

separation with the antenna while this end product is installed and operated. The end user has to be

informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can

be satisfied.

The end user has to also be informed that any changes or modifications not expressly

approved by the manufacturer could void the user's authority to operate this

equipment . If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19

statement is required to be available in the users manual:

This device complies with Part 15 of FCC rules. Operation is subject to the following two co

nditions: (1) this device may not cause harmful interference and (2) this device must

accept any interference received, including interference that may cause undesired operation.

LABEL OF THE END PRODUCT:

The final end product must be labeled in a visible area with the following " Contains

FCC ID: 2AVTT-BL62B ". If the size of the end product is larger than 8x10cm, then the following

FCC part 15.19 statement has to also be available on the label:

This device complies with Part 15 of FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.

To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and

operated with minimum distance between 20cm the radiator your body.