User's Manual
Table Of Contents
- 1. Product Overview
- 2. Pin definition
- 3. Electrical parameters
- 4. Reflow welding temperature curve
- 5. Application circuit
- 6. Contact Us
- Federal Communication Commission Statement (FCC, U
- FCC Caution:
- IMPORTANT NOTES
- OEM integration instructions:
- Validity of using the module certification:
- End product labeling:
- Information that must be placed in the end user ma
- Integration instructions for host product manufact
- 7.2 List of applicable FCC rules
- 7.3 Specific operational use conditions
- WiFi Specification：
- BLE Specification：
- 7.4 Limited module procedures
- 7.5 Trace antenna designs
- 7.6 RF exposure considerations
- 7.7 Antennas
- 7.9 Information on test modes and additional testi
- 7.10 Additional testing, Part 15 Subpart B disclai
BL-61C WIFI+BLE module
Copyright © 2020 ShenzhenJiXinInteligence Co., Ltd All Rights Reserved
Page
7
of 19
2. Pin definition
BL-61C module has 38 pins in total, as shown in Figure 2.1.
Peripherals include 13 GPIOs, 2 UARTs, 1 I2C master/slave, 4 PWM
channels, and 1 12-bit general-purpose ADC. Each GPIO can be used
Module model
BL-61C
Mounting
SMD-38
Size
25.5*18*3.5(±0.2)mm
Cert.
FCC、CE
Flash
Chip built-in 2MB
Interface
UART/GPIO/ADC /PWM/
I2C
IO 口
16
Number of GPIO
9600/19200/38400/115200/921600 bps , Up to 5Mbps
Freq.
2400 ~2483.5MHz
Antenna
Onboard PCB antenna
Security
WPS/WEP/WPA/WPA2 Personal/WPA2 Enterprise/WPA3
Power Supply
DC 3.0V ~ 3.6V，Imax >300mA
Temperature
-30 ℃ ~ 85 ℃
Storage
Condition
-45℃ ~ 135℃ ,< 90%RH