User's Manual
Table Of Contents
- 1. Product Overview
- 2. Pin definition
- 3. Electrical parameters
- 4. Reflow welding temperature curve
- 5. Application circuit
- 6. Contact Us
- Federal Communication Commission Statement (FCC, U
- FCC Caution:
- IMPORTANT NOTES
- OEM integration instructions:
- Validity of using the module certification:
- End product labeling:
- Information that must be placed in the end user ma
- Integration instructions for host product manufact
- 7.2 List of applicable FCC rules
- 7.3 Specific operational use conditions
- WiFi Specification：
- BLE Specification：
- 7.4 Limited module procedures
- 7.5 Trace antenna designs
- 7.6 RF exposure considerations
- 7.7 Antennas
- 7.9 Information on test modes and additional testi
- 7.10 Additional testing, Part 15 Subpart B disclai
BL-61C WIFI+BLE module
Copyright © 2020 ShenzhenJiXinInteligence Co., Ltd All Rights Reserved
Page
19
of 19
Operation Frequency:
2402~2480MHz Number of
Channel: 40
Modulation: GFSK
WIFI
Operation Frequency:
2412~2462MHz Number of
Channel: 11
Modulation: DSSS, OFDM
Host manufacturer must perfom test of radiated & conducted emission and spurious emission, etc
according to the actual test modes for a stand-alone modular transmitter in a host, as well as for
multiple simultaneously transmitting modules or other transmitters in a host product. Only when all
the test results of test modes comply with FCC requirements, then the end product can be sold
legally.
7.10 Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for FCC Part 15 Subpart C 15.247 & 15.207 &
15.209 and that the host product manufacturer is responsible for compliance to any other FCC rules
that apply to the host not covered by the modular transmitter grant of certification. If the grantee
markets their product as being Part 15 Subpart B compliant (when it also contains unintentional
radiator digital circuity), then the grantee shall provide a notice stating that the final host product still
requires Part 15 Subpart B compliance testing with the modular transmitter installed.