User's Manual
Table Of Contents
- 1. Product Overview
- 2. Pin definition
- 3. Electrical parameters
- 4. Reflow welding temperature curve
- 5. Application circuit
- 6. Contact Us
- Federal Communication Commission Statement (FCC, U
- FCC Caution:
- IMPORTANT NOTES
- OEM integration instructions:
- Validity of using the module certification:
- End product labeling:
- Information that must be placed in the end user ma
- Integration instructions for host product manufact
- 7.2 List of applicable FCC rules
- 7.3 Specific operational use conditions
- WiFi Specification：
- BLE Specification：
- 7.4 Limited module procedures
- 7.5 Trace antenna designs
- 7.6 RF exposure considerations
- 7.7 Antennas
- 7.9 Information on test modes and additional testi
- 7.10 Additional testing, Part 15 Subpart B disclai
BL-61C WIFI+BLE module
Copyright © 2020 ShenzhenJiXinInteligence Co., Ltd All Rights Reserved
Page
18
of 19
Not applicable. The module has its own antenna, and doesn
’
t need a host
’
s printed board microstrip
trace antenna etc.
7.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained between the
antenna and users
’
body; and if RF exposure statement or module layout is changed, then the host
product manufacturer required to take responsibility of the module through a change in FCC ID or new
application. The FCC ID of the module cannot be used on the final product. In these circumstances, the
host manufacturer will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization
7.7 Antennas
Antenna Specification are as follows:
Type: PCB
Antenna Gain: 2
dBi
This device is intended only for host manufacturers under the following conditions: The transmitter
module may not be co-located with any other transmitter or antenna; The module shall be only used
with the internal antenna(s) that has been originally tested and certified with this module. The antenna
must be either permanently attached or employ a
‘
unique
’
antenna coupler.
As long as the conditions above are met, further transmitter test will not be required. However, the host
manufacturer is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.)
7.8 Label and compliance information
Host product manufacturers need to provide a physical or e-label stating “Contains Transmitter
Module FCC ID: 2AVTT-BL61C” with their finished product.
7.9 Information on test modes and additional
testingrequirements BLE